How to Remove a Nissan Pulsar Front Bumper Bar

If you have damaged the front bumper or are just modifying your Nissan Pulsar your going to need to know how to remove the front bumper. The Nissan Pulsar's front bumper is held in place on the frame by about 12 screws and bolts. To excess the lower bolt your going to have to lift the front end using a jack. There are a number of bolts inside the engine compartment that your going to have to remove as well.
Difficulty: Moderately Easy
Instructions
Things You'll Need
Jack
Ratchet set
Screw driver
1

Raise the front end of the Nissan Pulsar using a jack. Look under the frame and locate the securing bolts holding the front bumper to the frame.
2

Remove the lower bolts under the Pulsar's frame using a ratchet set. Remove all of the screw that are holding the front bumper to the frame using a screw driver.
3

Open the Nissan Pulsar's hood and locate the securing bolts on the right and left side of the radiator.
4

Remove the securing bolts on the right and left side of the radiator using the ratchet set. Remove the screw that are securing the front bumper to the frame using the screw driver. Disconnect all of the plastic locking tabs connecting the front bumper to the frame as well.
5

Pull the front bumper off of the frame.